Setting The Zigzag Base Line Position - Brother ZE-855A Bedienungsanleitung

7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES

7-2-3. Setting the zigzag base line position

The zigzag base line is the "center" of the zigzag stitch, or in other words, it is like a center line drawn through the
sewing pattern.
By moving the zigzag base line position, you can move the sewing pattern to the left and right within the maximum
range for the pattern width.
Zigzag width Zigzag width
Base line Base line
e
r
[L] or [r]
I Zigzag base line position indicator w
If the zigzag base line position has been set to something other than
will illuminate so that you can check whether the zigzag base line position has been set to a position other than the
center.
G Relationship between zigzag base line position and zigzag width (when the maximum zigzag width is 8 mm)
By way of example, consider a sewing pattern (Figure A) with a zigzag base line position set to
width set to AA AA. If the zigzag base line position is set to
edge (Figure B). The sewing pattern cannot move any further to the left even if a larger setting is made. (Even if the
zigzag base line position is set to
(Figure C.)
AA AA
However, in this case, if the zigzag width is set to
produced.
<Example> (8mm)
A
4mm
Base line
-------- 0
-------- 4.0
Zigzag width
79
Zigzag width Zigzag width
Base line Base line
1338M
w q
1439M
AA AA, the sewing pattern position will be the same as if the setting had been
AA
(8mm)
B 4mm
L2.0
4.0
ZE-855A,856A
Maximum zigzag width (8 mm)
Zigzag width 3mm
Base line 0
1. Press the zigzag base line position key q.
The indicator w will illuminate, and the zigzag base
line position currently set will flash on the LED display
e.
(For example, AA AA
tion is 2.0 mm to the left, and
pattern position is 2.0 mm to the right.)
2. Press the and
zigzag base line position.
• If changing the setting from
numerals, and then set "L" or "r".
• Use the selection keys to set [L] or [r] in the
second column from the left in the LED display e.
Note:
If the needle bar is at the needle up stop position, the
needle bar will move to the sewing start position when
the zigzag base line position is changed.
If the needle bar is not at the needle up stop position,
the needle bar will move to the sewing start position
after it next moves to the needle up stop position.
AA, the zigzag base line position indicator w
AA
AA AA, the pattern will be moved over toward the left
AA, a sewing pattern such as that shown in Figure D will be
(8mm)
C
4mm
L3.0
4.0
(8 mm)
3mm
Base line 0
2 mm to the left
Base line
indicates that the pattern posi-
AA AA indicates that the
selection keys r to change the
AA AA, first change the
AA AA and a zigzag
(8mm)
D
2mm
L3.0
2.0
1339M
1341M