Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tool Specifications
Angle Grinder
Order number
Rated input power*
Output power*
No-load speed
Grinding disc dia., max.
Grinder spindle thread
Weight without cable, approx. 1.40 kg
Protection class
*The values given are valid for nominal voltages [U] of 230/
240 V. For lower voltages and models for specific coun-
tries, these values can vary.
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 88 dB (A); sound
power level: 102 dB (A).
Wear hearing protection!
The typically weighted acceleration is 5 m/s
Operating Controls
1 Ventilation slots
2 On/Off switch
3 Auxiliary handle
4 Spindle lock button
5 Grinder spindle
6 Protection guard
7 Clamping lever
8 Mounting flange with O-ring
9 Grinding/cutting disc*
10 Clamping nut
11
quick-clamping nut*
12 Hand guard*
13 Rubber sanding pad*
14 Sanding sheet*
15 Round nut*
16 Cup brush*
17 Diamond cutting disc*
18 Cutting guide with dust extraction protection
guard*
19 Cutting grinder stand*
20 Length stop*
* Not all of the accessories illustrated or described are
included as standard delivery.
12
GB
BTI-WKS 125
015863
670 W
410 W
11 000 rpm
125 mm
M 14
/ II
2
.
For your Safety
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions
contained
strictly followed. In addition, the
general safety rules in the safety
rules section must be observed.
Before using for the first time,
ask for a practical demonstra-
tion.
Wear protective glasses and hearing protec-
tion.
Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the workplace clean, as blends of
materials are particularly dangerous.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always direct the cable to the rear away from
the machine.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
For power outage or when the mains plug is
pulled, unlock the On/Off switch immediately
and turn it to the off position. This prevents un-
controlled restarting.
therein
are
Werbung
Inhaltsverzeichnis
