During Work On Vehicle - Beissbarth Tesla VLH 2140 Originalbetriebsanleitung

en 32 | VLH 2140 | Operation
6.5 Vehicle lifting
DANGER – Risk of vehicle falling or tilting!
Risk of (fatal) injury on lifting (or raising) the
support arms.
¶
Make sure there is no-one in the vehicle or
in the area of the lifting platform.
¶
Keep away from the support arms and the
vehicle.
¶
Observe the support arms, the jacking
points and the vehicle.
1. Pull the locking handle and press the control lever
upwards (o) for approx. 1 second.
 The support arms move upwards for as long as
the control lever is being pressed upwards.
2. Stop and check locking of the support arms. If
necessary, move the support arm slightly to engage
it.
3. Raise the vehicle until the tires are no longer in
contact with the ground. Then stop.
!
If the front and rear axles are not raised evenly, the
vehicle is incorrectly positioned. In this case: Lower
the support arms, re-position the vehicle and repeat
the lifting operation.
4. Check that the mounts are in firm contact with the
jacking points.
!
If the vehicle is not stable: Lower the support arms, re-
position the vehicle and repeat the lifting operation.
5. Continue raising the vehicle after ensuring its stability.
6. Raise as far as the required height or to the upper
end position and then release the control lever.
"
The lifting platform is raised and locked.
|
1 692 826 073 2017-03-29
6.6

During work on vehicle

DANGER – Risk of vehicle falling or tilting!
Risk of (fatal) injury whilst using lifting platform.
¶
Do not walk under the vehicle if it is not
firmly positioned on the runways or the
wheel-free scissor lift.
¶
Avoid subjecting the vehicle to severe
vibration.
¶
Never cause the vehicle or lifting platform
to vibrate.
¶
Always use safety devices if heavy
components (e.g. engine, transmission) are
being removed or attached. Fit the safety
devices to reach towards the vehicle rather
than lowering the vehicle onto the safety
devices.
Beissbarth GmbH