Setting The Time Zone; Restart / Set-Up - Junghans J615.61 Bedienungsanleitung

8. Setting the time zone

If you travel to countries with a time zone differing from Central European
Time (CET) or Central European Summer Time (CEST), you can set the current
local time using the T2 time zone button.
x Press the T2 button for less than 3 seconds (use a suitable pointed tool).
The LCD will display the current hour (24 hr. format).
x Each time you press the T2 button again, you advance the hour in 1-hour
steps (+)
Example: If you want to change the the hour from 15.00 to 16.00, press the
T2 button once.
x Using the 24-hour display on the LCD, you can check if the time you
wanted is correct.
x 9 seconds after last pressing the button, the LCD reverts automatically to
the corrected date.
x If you press the T2 button for longer than 3 seconds, the LCD will revert to
CET or CEST.
Due to the internal memory, this is can also be done at any time outside
the transmitter range, e. g. on long-distance trips.
34

9. Restart / set-up

After changing the battery, the watch is automatically restarted. Please note:
The battery should only be changed by an authorised specialist or the
Junghans Service Centre.
Reception of the DCF 77 signal commences. Given good reception, the exact
time will be displayed after a few minutes.
If your radio-controlled watch is unable to pick up a signal, it will auto-
matically retry later on. In the meantime you can also set your radio-con-
trolled watch manually. This also applies if you are outside the DCF 77 trans-
mitter range and want to restart your radio-controlled watch after changing
the battery. In this case, your radio-controlled watch will show the time using
the 32 kHz quartz movement. You can set the desired time by pressing the T2
button.
The LC display will guide you (minutes are displayed from 0 to 59).
Press button once = minute hand advances by 1 minute
Keep button pressed = hands will advance until button is released
Note: In this special case, the date is not displayed. Instead, the signal control
displays the number "1 ".
The adjusted time is kept until trouble-free contact with the DCF 77 time
signal transmitter is possible. The date is displayed again once the time
signal has been received.
35