Setting Your Digital Surround Sound Receiver; Receiving A Digital Audio Signal; Setting Your Analog Surround Sound Receiver - Bose Acoustimass 6-Serie V Bedienungsanleitung

Setting your digital surround sound receiver

Speakers in your Acoustimass
surround receivers. The system's integrated signal processing supports full low-frequency reproduction from all channels.
To gain complete advantage of these system capabilities, you may want to adjust some settings on your receiver. To make changes,
use the digital display menu on the receiver and refer to the list of recommended settings below.
Speaker
Left and right
Center
Left and right surround
LFE/Subwoofer
Note: If your receiver provides it, the LFE or Subwoofer option setting should be ON and the crossover value at the lowest number
possible, which is typically 80 Hz.

Receiving a digital audio signal

For the digital audio signal from additonal sources (Blu-ray
receiver, you need a digital audio connection between the additonal source and receiver.
• Use either the HDMI , Optical or Coaxial input on the receiver to connect to the digital output from the additional source. Do not use
™
more than one connection.
• Be sure to select the digital output in the setup menu of your additional source.
For additional setup and operating information, please refer to the owner's guide that came with your surround receiver.

Setting your analog surround sound receiver

For analog (non-digital) surround sound applications, we recommend that you set the surround sound center mode of your receiver to
Wide. For instructions on how to change this setting, refer to the owner's guide provided with your surround receiver.
6 series V or Acoustimass 10 series V system are fully compatible with the audio output of digital
®
Receiver setting
LARGE
LARGE
LARGE
ON
HDMI
or DVD player, CBL/SAT box, gaming system, etc.) to reach your surround
™
HDMI
Using Your System
English - 11