General System Information; Start-Up; Teaching-In - HomeMatic HMIP-WTH Montageanleitung Und Bedienungsanleitung

Function and device overview
Device overview (see figure 1):
(A) Clip-on frame
(B) Electronic unit (thermostat)
(C)
Display
(D)
System button (teach-in button and LED)
(E) Control wheel
(F) Mounting plate
Display overview (see figure 2):
Setpoint/actual temperature and
(G)
humidity
(H) Manual operation
(I) Boost function
(J) Operating lock
(K) Open window symbol
(L) Radio transmission
(M)
Battery symbol
34
4

General system information

This device is part of the climate control solution of
Homematic IP and works with the HmIP radio protocol.
All devices of the climate control solution can be config-
ured comfortably and individually with a smartphone via
the Homematic IP app. The available functions provided
by the Homematic IP system in combination with other
components are described in the Homematic IP User
Guide. All current technical documents and updates are
provided at www.eQ-3.de.
5

Start-up

5.1

Teaching-in

Please read this entire section before starting
the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the wall thermostat into your system and en-
able it to communicate with other Homematic IP devices,
you must teach-in the device to your Homematic IP Ac-
cess Point first.
General system information
35