Connection Of An External Amplifi Er; Connecting An External Subwoofer - Silvercrest SAB 160 B2 Bedienungsanleitung

NOTE
► Ensure that a permanent plus connection is applied to the station memory
of connector 4 in ISO Block A
► In some vehicle models, the default assignment of connectors [4] and [7] in
ISO Block A are interchanged at the factory. If this is the case, the station
memory can be lost. To remedy this, connectors 7 (ignition positive) and 4
(permanent plus) in ISO Block A must be swapped. To do this, connect the
supplied adapter cable
the car wiring harness. Use the adapter cable to connect the red wire of
the ISO plug to the green wire in the ISO socket, and the yellow wire of the
ISO plug to the red wire in the ISO socket (see also back fold-out page)
CAUTION
► When using the adapter cable for the ISO Block A, both connections (red
and yellow wires) must be connected together. Otherwise there is a risk of
a short circuit!
Aerial control voltage connection
CAUTION
Possible damage to the device
► Never load the aerial control voltage with the motor power cable or other
power consumers.
The connector for the aerial control voltage is available for a relay-controlled
aerial. The relay then automatically extends the aerial out when the device is
switched on. When switched off , the aerial retracts back in. This connector can
also be used to control an external amplifi er. For exact connector information,
please consult the operating instructions for the amplifi er.
Connection of an external amplifi er
For the connection of an external amplifi er use the audio cinch output LINE
OUT
31
doing this.

Connecting an external subwoofer

Use the orange SUB-W cinch output
To do this, follow the operating instructions for the external subwoofer.
SAB 160 B2
between the ISO-Block A on the car stereo and
42
. Follow the operating instructions for the external amplifi er when
.
28
to connect an external subwoofer.
30
GB
123