Herunterladen Inhalt Inhalt Diese Seite drucken

Nolan N94 Sicherheit Und Gebrauchsanleitung Seite 12

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
3.2 Make sure that all couplings match. Then hook the front portion, then the rear of the
liner.
3.3 Carefully adjust the liner until it adheres well to the shell.
3.4 Check that the frame of the front section is well inserted underneath the window trim
edge.
4
Cheek pad assembly (Fig. 4)
4.1 Put the hard plastic flap between the cheek pad and the shell.
4.2 Make sure that the cheek pad is in the correct position so that all the snap buttons are
in line with their housings.
4.3 Insert the hard flap all the way into the groove under the base edge and hook the four
buttons.
Attention: the buttons are not hooked until a click is heard.
4.4 Check that the strap comes out properly from the cheek padding.
4.5 Repeat steps 4.1 to 4.4 on the other side of the cheek pad.
ATTENTION!!!
-
If your helmet is equipped with the D-Ring retention system, pull it down as
indicated in the attached D-Ring label.
-
Remove the padding only when cleaning or washing is required.
-
Never use the helmet prior to having correctly and completely refitted the inner com-
fort padding and the cheek pads.
-
Never machine-wash the inner comfort padding.
-
Never use tools or equipment of any sort to carry out the steps described above.
• NFRS – NOLAN FOG RESISTANT SYSTEM
(uses the patent licence of
1 INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Remove the protective film from the inner visor on the face in contact with the visor.
1.3 Check that the inner surface of the visor is clean.
Attention: the presence of dust between the visors can produce scratches on both
surfaces.
1.4 Rest one side of the inner visor on one of the visor pins and hold it in position (see
Fig. 6).
1.5 Open the visor and fasten the other side of the inner visor to the second pin (see
Fig. 7).
1.6 Release the visor.
1.7 Remove the second protective film from the inner visor.
Attention: Check that both visors are tightly connected and do not move; if they do,
adjust the spring pins using a screwdriver to set the adherence (Fig. 8).
1.8 Fit the visor in the helmet.
Pinlock
®
)
12

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis