Grammer PRIMO L Bedienungsanleitung Seite 19

Safety instructions
To prevent injury, of the driver's
seat.
of the driver's seat, possible has to be
removed from the seat cushion and the backrest upholstery.
To eliminate any risk of accident, the settings must be checked to ensure they are
correctly engaged .
Adjustments must be made .
, the backrest frame must be supported, for
example held in place, before the backrest adjuster is operated. If you fail to do so, there
is a danger that the backrest frame may jerk forward and .
(for example fitting parts which are not
original parts) may impair the safety standard to which it has been tested.
, threatening your . For this reason,
must be approved by .
During the removal and installation of the driver's seat, the corresponding instructions by
the specific vehicle manufacturer must be strictly observed!
Do not hold onto the covers for lifting the driver's seats. If you do so anyway, there is an
.
Before you remove the driver's seat, disconnect all plug-in connections between the seat
and the vehicle supply network. When you replace the plug-in connectors, make sure they
are tight (dust, water).
Seatbelts can be retrofitted to the driver's seat. Seatbelts
, as they increase the load in the seat mounting
area.
Seatbelts must be fitted in accordance with specific national regulations and guidelines,
and must be approved by .
Retrofitted seatbelts must be fastened .
after an accident.
Where seatbelts are fitted to the driver's seat, the and must be
checked by specialist personnel after an accident has occurred.
Fasteners must be . If the seat wobbles there may be
loose bolts or other faults.
If you notice that the seat does not function correctly (for example a defective seat
suspension; improper curvature of the lumbar support or damaged bellows),
to arrange for repairs to be carried out.
If you fail to do so, your health may be affected and the .
GB
19