Troubleshooting - Stanley SLM-196-510-SP Übersetzung Der Original-Anleitung

10. Troubleshooting

Problem
Engine does not
start
Engine starts but
equipment does
not run at full
power
Engine splutters,
stops
Engine overheats
Drive does not
switch on
Output unsatisfactory
or engine
labouring
Blade does not
turn
Abnormal noises,
rattling or vibrations
Possible Cause
Too little petrol in the tank
Incorrect starting sequence
Spark plug connector ( 12)
not put on correctly
Sooted spark plug
Incorrectly adjusted carburettor
mix
Dirty air filter ( 14)
Incorrectly adjusted carburettor
mix
Incorrectly adjusted carburettor
mix
Sooted spark plug ( 12)
Ventilation slot blocked
Incorrect spark plug (12)
Too little engine oil in the engine
Bowden cables ( 4) misadjusted
Grass too short or too long
Blade blunt
Blade blocked with grass,
grass collection box full, ejection
channel blocked
Blade blocked with grass
Blade not installed correctly
Blade not installed correctly
Blade damaged
Fault Correction
Fill with petrol
Follow the instructions for starting
the engine (see "operation")
Attach the spark plug connector
Clean, adjust or replace the spark
plug (see "cleaning and maintenance")
Have the carburettor adjusted by a
specialist workshop
Replace the air filter (see "cleaning
and maintenance")
Have the carburettor adjusted by a
specialist workshop
Have the carburettor adjusted by a
specialist workshop
Clean, adjust or replace the spark
plugs (see "cleaning and maintenance")
Clean the ventilation slot
Change the spark plug
Fill with engine oil
Have adjustment carried out by a
specialist workshop
Change the cutting height (see
"setting the cutting height")
Have the blade sharpened or replaced
by a specialist workshop
Remove the grass (see "cleaning
and maintenance")
Remove the grass
Have the blade installed by a specialist
workshop
Have the blade installed by a specialist
workshop
G
B
15