Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DecoRoll 300 Set
interruption of work
•
During extended break periods, wrap your roller cover in a plastic bag to keep it from
drying out.
•
Close the original container to stop the surface of the paint forming a skin.
cleanup
Clean the roller only with water (warm and soapy water is recommended).
i
1.
Remove the pump unit by turning the bayonet catch to take it off the paint cylinder.
(fig. 9)
2.
Hang the roller frame from the original container by the edge of the trigger. (Fig. 10)
3.
Fill the remaining paint back into the original container (fig. 11).
4. Attach the suction adapter to the paint cylinder using the bayonet catch (fig. 2).
5.
Dip the suction attachment into a bucket of water and move the handle back and
forth several times (fig. 12).
The cleaning adapter makes cleaning much easier. When you use the cleaning
i
adapter, please following instructions given in the section, "Cleaning with the
cleaning adapter". If the adapter does not fit your tap, follow the instructions
given in the section, "Cleaning without the cleaning adapter".
cleaning with the cleaning adapter
6.
Remove the aerator (Perlator) from your tap and attach the cleaning adapter to the
tap (fig. 13).
7.
Screw the pump unit to the cleaning adapter (fig. 14).
8.
Turn on the tap and let the water run for about 5 minutes.
While the water is running pull the trigger a few times and spin the paint roller
i
by hand. This helps the cleaning process.
9.
Turn off the tap and remove the pump unit.
10.
Disconnect the cleaning adapter from the tap.
11.
Put the aerator (Perlator) back into the tap.
12.
If you have been using the FineLiner, clean the side-frame and brush under running
water.
13.
Unscrew the roller frame from the pump unit and detach the paint roller from the
roller frame (fig. 15).
to finish off the cleaning process, please follow the instructions in the section,
"preservation".
GB
11
Werbung
Inhaltsverzeichnis
