Pkm EB-C5-3KBTC Bedienungsanleitung Seite 39

Ensure before the installation
 The worktop must be rectangular and plane and made of heat-resisting material.
Structural elements should not interfere with the installation area.
 The installation must meet the safety requirements as well as the legal rules and
regulations.
 The wall sat the hob should be covered with heat-resistant material, e.g. ceramic
tiles.
 The power cable must not come into contact with cabinet doors or drawers.
 The appliance must be supplied with an adequate flow of fresh air from outside
the cabinet to the base of the hob.
 If the hob is installed above an oven, the oven must be equipped with a cooling
system.
 Install a thermal protection below the bottom of the appliance when installing it
above a drawer or a cupboard.
 The circuit breaker must be easily accessible.
Selection of installation equipment
Cut out the installation hole as described on the drawing below. For installation and
use, a minimum of 50 mm space shall be preserved around the hole. The thickness
of the work top should be at least 30 mm. Choose heat-resistant materials for the
work top only to avoid any deformation caused by the heat-radiation of the
appliance.
L (mm) W (mm)
770 520
H (mm) D (mm)
52 48
39
A (mm) B (mm)
740 490
1. seal
X (mm)
50 min.