Installing The Refrigerator - Dometic COOLMATIC CRX50 Montage- Und Bedienungsanleitung

Installing and connecting the refrigerator
• Observe the following installation dimensions:
– CRX50: 550 x 390 x 544 mm
– CRX65: 595 x 458 x 535 mm
– CRX80: 578 x 485 x 650 mm
– CRX110: 608 x 530 x 755 mm
– CRX140: 670 x 535 x 825 mm
• Keep objects clear of openings in the housing or installation structure (such as
ventilation slots, etc.).
• Condensate is produced when the refrigerator is operating normally. You can
either wipe up the condensate on the floor of the refrigerator in regular intervals,
or drain it through an outlet in the floor of the refrigerator (see chapter "Mounting
the outlet port (optional)" on page 20).
7.3 Mounting the outlet port (optional)
➤ Connect a hose with an inside diameter of 10 mm (not included) to the outlet
port.
➤ Lay the refrigerator on its side in order to access the bottom side.
➤ Mount the outlet port (fig. 9 2, page 6) aligned to the front or to the back
according to the desired outlet direction.
➤ Remove the drain plug (fig. 9 1, page 6) inside the refrigerator.
7.4

Installing the refrigerator

Proceed as follows to install the refrigerator:
➤ If you wish to drain the condensate through a hose:
Mount the outlet port (see chapter "Mounting the outlet port (optional)" on
page 20)
➤ Undo the transport lock (chapter "Releasing the lock" on page 27).
➤ Open the refrigerator door.
➤ Remove the blanking plugs (fig. 0 2, page 6).
➤ Push the refrigerator into the recess.
➤ Fix the refrigerator in place using suitable screws (fig. 0 1, page 6).
➤ Press the blanking plugs (fig. 0 2, page 6) into the openings.
20
CRX
EN