TERMA MEG Gebrauchsanweisung Seite 21

MOA
temperature regulation
turn on/off button
Turning the device on with the
will result in the radiator heating up to the
set temperature. After reaching the set
temperature the device will turn off and
on regularly in order to maintain the set
temperature.
The construction of the device as well as
the physical characteristics of the heating
agent inside the radiator, influence the way
in which the heat is distributed — the tem-
perature of the bottom pipes on the ra-
diator (especially the two located at the
very bottom of the radiator), may be low-
er than the temperature of the remain-
ing parts of the radiator — this is a normal
phenomenon.
Temperature increase
In order to increase the temperature of the
radiator, press once or several times as
required; the correct number of diodes will
EN
dryer function
button start blinking. The last blinking diode indi-
cates the set temperature, whilst the last
diode which shines constantly, indicates
the current temperature. The remaining di-
odes will start shining constantly on reach-
ing subsequent temperature levels.
Temperature decrease
In order to decrease the temperature of
the radiator, press
as required; the correct number of diodes
will start blinking. The last diode, which
shines continuously, indicates the set tem-
perature whilst the last blinking diode in-
dicates the current temperature. The re-
maining diodes will start fading on reaching
subsequent temperature levels.
once or several times
21