Warranty; Declaration Of Conformity - Mesto REKORD 3533S Gebrauchsanleitung

GB IRL
Fault
Only a spray, emerges,
there is no atomization.
Liquid dripping from the
nozzle.
Device sprays only when
pumped.
The shut-off valve does
not close.
Liquid emerges without
the lever being activated.
Contact address for additional information → see title page.

Warranty

We guarantee that from the time it is first purchased for a period of the legally valid required
warranty period (maximum 3 years) this device will not exhibit any material or processing
errors. If defects are discovered during the warranty period, MESTO or the distributor in
your country will repair the device without charging for the labor or material or (at the
discretion of MESTO) replace the device itself or its defective parts.
If such defects are discovered, please contact us immediately. We require the invoice or
cash register receipt for purchase of the device.
The warranty does not include wearing parts (seals, O-rings, diaphragm, etc.) or defects,
which have occurred due to improper use or unforeseeable circumstances.

DECLARATION OF CONFORMITY

according to EC Machinery Directive 2006/42/EC, Appendix II, No. 1A.
We,
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71
D-71691 Freiberg
declare under our sole responsibility that the products backpack spraying devices of the
series 3533 from factory number 1289536 in the version supplied comply with all relevant
provisions of the Directive 2006/42/EC. Rolf Rehkugler, Ludwigsburger Str. 71, D- 71691
Freiberg, is authorized to compile the technical documentation.
Freiberg, 15.12.2011
Bernd Stockburger
- Managing Director –
AUS USA
Cause
Nozzle insert [23] is missing.
Foreign object in the nozzle
[22] or / and the insert [23].
Union nut on the angle piece
[31] not screwed tight.
Pressure vessel completely
filled with liquid.
O-ring [32] of the pressure bolt
[33] not greased.
O-ring [32] defective.
17
NZ CDN
Remedy
Position the insert in the
nozzle. (Fig. 14)
Clean nozzle and / or insert.
Tighten union nut. (Fig. 22)
Pump device completely empty.
Repeat after 5 fillings at the
latest.
Grease the O-ring of the
pressure bolt.
Replace the pressure bolt or O-
ring. (Fig. 23)
IND