BGS technic 63400 Bedienungsanleitung Seite 8

WARNING
To avoid possible electric shock or personal injury, follow these guidelines:
1. Do not use the meter if it is damaged. Before you use the meter, inspect the case. Pay particular
attention to the insulation surrounding the connectors,
2. Inspect the test leads for damaged insulation or exposed metal. Check the test leads for
continuity. Replace damaged test leads before you use the
meter.
3. Do not use the meter if it operates abnormally. Protection may be impaired. When in doubt, have
the meter serviced.
4. Do not operate the meter around explosive gas, vapor, or dust.
5. Do not apply more than the rated voltage, as marked on the meter, between terminals or between
any terminal and earth ground.
6. Before use, verify the meters Operation by measuring a known voltage.
7. When measuring current, turn off circuit power before connecting the meter in the circuit.
8. Remember to place the meter in series with the circuit.
9. When servicing the meter, use only specified replacement parts.
10. Use with caution when working above 30V ac rms, 42V peak, or 60V de.
11. Such voltages pose a shock hazard.
12. When using the probes, keep your fingers behind the finger guards on the probes.
13. Connect the common test lead before you connect the live test lead.
14. When you disconnect test leads, disconnect the live test lead first.
15. Remove the test leads from the meter before you open the case.
16. Do not operate the meter with the cover removed or loosened.
17. To avoid false readings, which could lead to possible electric shock or personal injury, replace the
battery as soon as the low battery indicator appears.
18. Remaining endangerment:
When an input terminal is connected to dangerous live potential it is to be noted that this
potential at all other terminals can occur!
19. CATII-Measurement Category II is for measurements performed on circuits directly connected to
low voltage installation. Do not use the meter for measurements within Measurement Categories
IM and IV.
CAUTION
To avoid possible damage to the meter or to the equipment under test, follow these guidelines:

Disconnect circuit power and discharge all capacitors before testing resistance, continuity, diode
and temperature.

Use the proper terminals, function, and range for your measurements.

Before measuring current, check the meter's fuse and turn power OFF to the circuit before
connecting the meter to the circuit.

Before rotating Function / Range switch to change functions, disconnect test leads from the circuit
under test.
SW-Stahl und Werkzeugvertriebs GmbH
L e v e k r u s r e t S a r s s e 6 5
D 4 - 2 8 9 7 R e m s c h e d i
Tel. +49 (0) 2191 / 46438-0
F ax +49 (0) 2191 / 46438-40
- E M a : l i n i o f @ s w s a t l h d . e