M (Manual) Mode; High Speed Sync; Freeze Mode - Rollei HS Freeze 4 Anleitung

Operation
30

M (manual) Mode

1 . Enter Menu 1 and press the second function button repeatedly until the
display shows M on the LCD .
2 . Press the third function button to change the sync mode . Choose between
normal mode, high speed mode and freeze mode .
3 . Enter Menu 2 to set the channel and the group of the flash .
4 . Choose the wireless remote control mode according to the trigger
that you are using .
5 . In manual mode the power can be set from 1 .0 ~ 9 .0 . The minimum power
output is 1 .0 and the maximum one is 9 .0 . For a small adjustment in increments
of 0 .1 f stop just rotate the power output wheel and the value will be adjusted
accordingly . For large adjustments press the power output wheel once and
then rotate it and the value will be changed by 1 f stop .

High Speed Sync

If high speed sync is activated the icon
In this sync mode you can set the shutter speed up to 1/8000s, to synchronize the
speed with the flash . The power output in this sync mode can only be set
between 4 .0 up to 9 .0 .

Freeze Mode

If the freeze mode is activated the icon
In this mode the maximum shutter speed is limited to the normal flash sync time
(normally 1/250s), but the flash can be fired with speeds of up to 1/19000s .
The power output in this sync mode can be set between 1 .0 up to 9 .0 .
ENGLISH
will be shown on the display .
will be shown on the display .