Installing The Junction Cable Guide - Pioneer SGY-PM900H79 Benutzerhandbuch

Installing the Junction Cable Guide

Attach the junction cable guide to the right-side transmitter.
•
The positions of the screw holes for fastening the junction cable guide are different for standard cranks and compact cranks.
This procedure uses a compact crank set for the explanation.
Compact crank set
1
Put the junction cable into the junction cable guide and install it within the inner ring.
•
Be careful that you do not force the junction cable.
•
Be careful that the junction cable is not pinched between the right transmitter and the junction cable guide.
2
While pressing on the junction cable guide, insert the 2 screws (provided), and tighten them with the
Philips screwdriver.
Check that the right transmitter is installed so it fits the shape of the chain ring.
Tighten the screw while pressing the junction cable guide against the inner chain ring.
Use a tool that can measure the torque to tighten the screws.
• Tightening torque: 15 cN•m
•
If the junction cable guide is not installed correctly, the sensor may fall off or be damaged.
This completes the installation of the sensor on the right crank set.
Standard crank set
EN
25