Herunterladen Inhalt Inhalt Diese Seite drucken

Checking/Replacing Battery Of Remote Control - Num'axes CANICOM 300 Expert Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 49
 B button: Booster
Press the B (Booster) button to stop your dog instantaneously.
You can choose the level of stimulation you think to be the best for an immediate effect. As a result, you do
not need to press the "+" button.
Those static stimulations are transmitted by the two contact points located on the collar for as long as the
button is pressed but no more than 8 seconds maximum.
If you press the B button for more than 8 seconds, the collar will automatically go into safety mode for a
few seconds before restarting itself normally.
The stimulation level selected thanks to the Booster button can be different for each collar.
Programming the Booster button for the dog A (red strap):
- press the "A" button for approximately 5 seconds until the stimulation level flashes on the LCD screen
- press the "+" or "-" button to modify the stimulation level
- press the "A" button to confirm the level selected
Renew the same procedure to program the Booster button for the dog B.
 "+" and "-": stimulation level control buttons
Use the +/- buttons for rapid adjustment of the level of stimulation of the receiver collar.
12 levels of stimulation are available for CANICOM 300 Expert.
Level 1: very weak stimulation – Level 12: strong stimulation
Always start with the lowest level of stimulation.
 Back-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off button
remote control (approx. ½ second).
C hecking/replacing battery of remote control
   
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be prepared
to replace the battery.
To check the condition of the battery, turn on the remote control and look at the battery level indicator on
the LCD screen. The symbols which appear indicate the following:
Battery fully charged
Weak battery: prepare to replace the battery
Dead battery: your product functions in safety mode and the system locks up. The battery must be replaced.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Gb - 27
of the

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis