First Use From New - Num'axes CANICOM 800 Expert Gebrauchsanleitung

First use from new


 Charge of the CANICOM Expert collar
To charge your collar, proceed in the following way:
− connect the charger to a wall outlet
− connect the power cord to the collar, after a few seconds, the green indicator light starts blinking
− when the battery is fully charged, the green indicator light goes out
− disconnect the charger from the collar and put the protection tab back in place
− disconnect the charger from the wall outlet
We advise you to fully charge the battery before the 1
A full charge takes approximately 3 hours.
You can purchase a car charger from your supplier at any time.
 Activate/deactivate the remote control
Remote control is supplied with battery(ies) fitted.
- Activate: press the On/Off button
2 or Diagram 3). Indications appear on the LCD screen.
- Deactivate: press the On/Off button
screen is out.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are
not using it for a long period.
 Activate/deactivate the receiver collar
You can activate/deactivate the collar with the magnetic key or with the remote control.
 Activate/deactivate the collar with the magnetic key
- Activate: move the magnetic key towards the collar so that it comes into contact with the red mark, hold
for 1 second (ref. Diagram 6). The green indicator light on the collar will flash indicating that the collar
is On.
- Deactivate: move the magnetic key towards the collar so that it comes into contact with the red mark,
hold for 1 second (ref. Diagram 6). The green indicator light on the collar flashes quickly then goes out
indicating the collar is Off.
If you have several collars, renew the same procedure for each one.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long
period.
Gb - 23
use.
st
located on the side of the remote control for 1 second (ref. Diagram
located on the side of the remote control for 1 second. The LCD