Footplate; Castors; Options - Seat; Options - Crutch Holder - Breezy Entree Gebrauchsanleitung

Options – Footplate
Footrest
The footrests can be flipped up to
make it easier to get into and out
of the chair. By loosening the
screw (1) the angle can be ad-
justed in the area of ± 15°. Then
re-tighten the screw (see Torque).
Lower leg length
By loosening the screw (1) the
lower leg length can be adjusted.
Loosen the screws and adjust the
tube with the footrest to the desi-
red position. Then re-tighten the
screw (see page on Torque). Make
sure that the gap to floor is not
below the minimum of 2.5 cm.
Legrests and Latch
The legrest can be swung in and
outwards.
Fit your legrest by inserting it with
the footplate(s) pointing toward the
outside. Then rotate it toward the
inside until it locks into place (1).
To remove the legrest, depress the
lever (2), swing the footrest towards
the outside and lift to remove it.
Make sure that the legrest is pro-
perly locked into place.
CAUTION:
The legrests should not be used to lift or to carry
the wheelchair.
Elevating legrest
To elevate:
Lift your lower leg and press the
release button. Pull the legrest
upwards and adjust it to the desi-
red height. As soon as you release
the button, the legrest will click
back into place.
To lower:
Lift your lower leg and press the
release button to unlock the
legrest to lower it (1). As soon as
you release the button, the legrest
will click back into place.
CAUTION:
The elevating legrest is not
allowed to be adjusted into the lowest position
to avoid any interference with the castors.
CAUTION:
Keep hands clear of the adjustment mechanism
between the frame and the movable parts of the
legrest while elevating or lowering the legrest.
CAUTION:
Legrests are not to be used for lifting or carrying
the wheelchair with an occupant.
1
2
1
1
Options – Castor
Adjustment of seat height and seat angle
The seat height can be adjustet by moving the
castor in the fork SH 47 cm (1), SH 51 cm (2).
and the rear wheel.
ATTENTION:
Adjust the seat height only parallel.
Options – Seat
Standard seat sling
The seat sling has Velcro ®
fastening on each side. This makes
it possible to re-tension it easily. To
re-tension the seat sling, fold the
wheelchair slightly. Remove the
screws (1).
By opening the Velcro ® fastening
the seat sling can now be re-adju-
sted. To re-assemble, follow the
procedure in reverse order. Make
sure that after the adjustment
work, all screws are re-tightened
(see page on Torque).
ATTENTION!
In order to ensure safety, at least 50% of the
Velcro ® surface must be in contact.
Options – Crutch Holder
Crutch Holder
This device permits crutches to be transported
directly on a wheelchair. It has a Velcro loop (1) to
fasten crutches or other aids.
CAUTION:
Never try to use or even remove the crutches or
other aids while moving.
2 1
1
2
1
15
BREEZY ENTRÉE