Intended Use - Worx WG800E Übersetzung Der Original-Anleitung

SyMBOLS
Read instruction handbook
Do not expose to moisture
Warning: cutting means continue
to run after the motor is switched
off
Keep bystanders away.
contains Li-lon battery. Battery
must be recycled or disposed of
properly.
Wear eye protection
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. check with your
Local Authority or retailer for
recycling advice.
Cordless shrub shear and edging shear

INTENDED USE

The product is intended for light trimming of
shrubs and lawn edges in domestic use.
BEFORE USING yOUR SHEAR
Your product battery is UNcHARGED and you
must charge once before using it for the first
time.
CHARGING
1. ChARGING ThE bATTERy
The battery charger supplied matches to the Li-
ion battery installed in the machine. Do not use
other battery chargers.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: the blade no longer move.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
2. ChARGING(See A)
Plug charger plug into a suitable power outlet
and afterwards plug your tool into the battery
charger, the charging indicator (red) will
illuminate at this time.
The charger indicator will turn into green when
charging is complete, then unplug the charging
plug from the wall socket and then remove the
tool from the battery charger.
IMPORTANT:
During the charging procedure, the handle of the
machine warms up. This is normal.
When not using for extended periods,
disconnect the battery charger from the socket.
Do not use the machine during the charging
procedure.
13
EN