Error Messages/Troubleshooting - Sanitas SBM 37 Gebrauchsanweisung

Step 1: SBM 37
Activate Bluetooth
ter 4 "Preparing the measurement", Bluetooth
Step 2: "HealthCoach" app
In the HealthCoach app, add the SBM 37 under
"Settings/My devices".
Step 3: SBM 37
take a measurement.
Step 4: SBM 37
data transfer immediately
following measurements.
• If Bluetooth® data trans-
fer has been activated,
data is by transferred after
having confirmed the user
memory by pressing the
pressing the START/STOP
button .
on your device (see chap-
®
Step 4: SBM 37
Data transfer at a later point:
• Go to memory mode
(chapter 7). Select the
desired user memory. The
Bluetooth transfer starts
®
automatically.
The HealthCoach app must be active to allow data transfer.
If your smartphone has a protective cover, remove this to ensu-
re that there is no interference during the transfer. Begin the
).
®
data transfer in the HealthCoach app.
8. Cleaning and storing the unit
• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under wa-
ter, as this can cause liquid to enter and damage the unit.
• If you store the device, no heavy objects should be placed on
top of it. The cuff line should not be bent sharply.
In such cases, repeat the measurement and/or data transfer.
Ensure that the cuff line is correctly attached and that you do
not move or speak during the measurement.

9. Error messages/troubleshooting

In the event of errors, the error message
display.
Error messages may appear if:
• it was not possible to record the pulse:
• you move or speak during the measurement:
• the cuff is fastened too tightly or loosely:
• errors occur during the measurement:
• the pump pressure is higher than 300 mmHg:
• the batteries are almost empty
• the data could not be sent via Bluetooth
29
_ appears on the
1;
2;
3;
4;
5;
6;
:
.
®