Fit the Bark Control Collar
Important: The proper fit and placement of your Bark Control Collar is
important for effective operation. The Vibration Points must have direct contact
with your dog's skin on the underside of his neck.
Please refer to page 3 for Important
Safety Information.
To assure a proper fit, please follow these steps:
1. Make sure that the battery is in the
"OFF" position.
2. Have your dog standing comfortably (A).
3. Center the Vibration Points underneath your
dog's neck, touching the skin (B).
Note: It is
sometimes
necessary to trim
the hair around
the Vibration
Points to make
sure that contact is
consistent.
4. Check the tightness of the
Bark Control Collar by
inserting one finger
between the strap and
the dog's neck (C). The
fit should be snug but
not constricting.
5. Allow your dog to wear the collar for several minutes, then recheck the fit.
Check the fit again as your dog becomes more comfortable with the Bark
Control Collar.
B
Do not shave the pet's neck as this may increase the risk
of skin irritation.
C
You should not make the collar any more tight than is
required for good contact. A collar that is too tight will
increase the risk of pressure necrosis in the contact area.
www.petsafe.net
A
SÍ
NO
7