Technical Data; Noise And Vibration - Ferm pdm1034 Übersetzung Der Orginalbetriebsanleitung

● Never put the machine down on a table or
a workbench before it has been switched off.
Electrical safety
3
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Do not use the machine if the mains cable or
the mains plug is damaged.
● Only use extension cables that are suitable for
the power rating of the machine with
a minimum thickness of 1.5 mm
a extension cable reel, always fully unroll the
cable.
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/5A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.

TECHnICAL DATA

Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. drill bit diameter
Wood
Concrete
Steel
Protection class
Weight

nOISE AnD VIBRATIOn

Sound pressure (L
Acoustic power (L
Uncertainty (K)
Impact drilling mode
Drill into metal
Uncertainty (K)
2
. If you use
2
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (fIg. A)
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
1. On/off switch
2. Lock-on button
PDM1034
3. Speed adjustment wheel
4. Forward/reverse switch
V~ 230
5. Switch for drilling / hammer drilling
Hz 50
6. Chuck
W 500
7. Main grip
min 0 - 3,000
-1
8. Auxiliary grip
min 0 - 48,000
-1
9. Depth stop
10. Chuck key
mm 25
11. Chuck key holder
mm 13
mm 10
ASSEMBLy
IP 20
4
kg 1.8
)
pa
)
wa
Wear hearing protection.
Before assembly, always switch off the
machine and remove the mains plug
PDM1034
dB(A) 97.7
dB(A) 108.7
dB(A) 3
m/s 18.64
2
m/s 2.98
2
m/s 1.5
2
5