Help; Static Ip Address - Linksys BEFSR11 Schnellstartanleitung

Help

The "Help" section contains the most frequently asked Internet connection
questions. If you have additional setup needs or you wish to get information on
the advanced features, see the User Guide (English only) on the Setup Wizard
CD-ROM, or visit the Linksys website.
1. I'm not sure what information I need from my Internet Service Provider (ISP) to
get my network up and running. What questions should I ask?
What type of connection is being used: dynamic IP address, static IP address,
or PPPoE?
• If you are using a dynamic IP address, you should ask:
- What is my Host Name (if needed)?
- What is my Domain Name (if needed)?
• If you are using a static IP address, you should ask:
- What is my IP Address?
- What is my Gateway?
- What is my DNS?
• If you are using PPPoE (typically used by DSL ISPs), you should ask:
- What is my User Name?
- What is my Password?
After you obtain your answers, follow the instructions in "Step 3: Configure the
Router," and enter the information on the Setup screen. In the WAN Connection
Type section, refer to the chart on the next page:
24
®
Instant Broadband Series
EtherFast Cable/DSL Routers
®
If you have this type
of connection:
DHCP (Dynamic IP 1. Select Obtain an IP Automatically as the WAN
Connection Type.
Address)
2. Click the Apply button to save the settings.

Static IP Address

1. Select Static IP as the WAN Connection Type.
2. Enter the WAN IP Address.
3. Enter the Subnet Mask.
4. Enter the Gateway Address.
5. Enter the DNS in the 1, 2, and/or 3 fields. You need to
enter at least one DNS address.
6. Click the Apply button to save the settings.
PPPoE 1. Select PPPoE as the WAN Connection Type.
2. Enter the User Name.
3. Enter the Password.
4. Click the Apply button to save the settings.
RAS, PPTP, or If you are using RAS (Singapore SingTel), PPTP (service in
HBS(BEFSX41 and Europe), or HBS (service in Australia), check with your
BEFSR81 only) ISP for the necessary setup information.
2. I'm having problems connecting to the Internet; what LEDs should be lit on the
front of the Router?
• At least one LED will light up for any
proper connection made on the back of the
Router—whether it is an Ethernet cable or
power cord.
For example, the following are typical LEDs that light up once a computer
and a cable or DSL modem are connected:
- When the Router is turned on (the power adapter is plugged into the
Router), the Power LED lights up.
- When an Ethernet cable is properly connected between a PC and the
Router's LAN Port, the LEDs for that port light up.
- When there is a connection to the cable or DSL modem, the WAN Link/Act
LED lights up.
Perform these steps:
25