Testing The Detector - Velleman PIR1300 Bedienungsanleitung

5.4

Testing the Detector

1. Test the detector at the point of time you feel the lamp needs to
be switched on.
2. Turn the SENS and LUX knobs fully clockwise; turn the TIME
knob fully anti-clockwise.
3. Switch on the power. The detector needs a warm-up time of
± 30 seconds before it will switch on the connected lamp. When
no signal is detected, the lamp will switch off after
± 10 seconds.
4. Turn the LUX knob fully anti-clockwise. The lamp should switch
off.
5.5 Setting the Detector
1. Turn the SENS and LUX knobs until the lamp switches on.
2. Now, set the switch-off delay with the TIME knob going from
± 10 seconds to ± 7 minutes.
3. Close the detector with the cover and tighten the screw.
V. 02 – 15/10/2015
PIR1300
5 ©Velleman nv