Emptying The Dust Canister; Cleaning The Motor Filter - Koenic KVC 3122 A Gebrauchsanweisung

Size - A5
English

Emptying the dust canister

Fig. If the suction power diminishes, the dust
15
canister must be emptied and the filters
must be cleaned. We recommend to
empty the dust canister outside of the
house.
a) Remove the suction hose from the
vacuum cleaner. Press both dust
container release buttons and remove
the container by bringing it forward.
b) To empty the dust canister, simply
press the release on the bottom so
that the bottom of the canister opens
and the dust falls out. Hold the dust
canister over a rubbish container
whilst you are emptying it.
c) Loosen the filter lid and remove the
entire filter insert from the dust
canister. Empty remaining dust from
the dust canister.
d) Re-assemble all of the components
that have previously been removed.
Assembly is carried out in reverse order.
When put in the filter insert, be aware
that the arrow of the filter points to
the handle of the container.
Cleaning the main filter
a) Loosen the filter lid and remove the
Fig. 16
entire filter insert from the dust
canister. Break down the filter into
all of its individual parts. Tap the
filter to remove the dust and clean all
other parts with water and dry them
thoroughly.
Troubleshooting
If there are any problems during operation, please refer to the following table. If problems cannot
be solved as indicated under Solution, please contact your retailer.
Problem
Product does not work
Product cannot absorb
dust or loses suction
power
12
IM_KVC3122_180608_V04_HR.indb 12

Cleaning the motor filter

Fig.
17
Never use the vacuum cleaner without a motor
filter, as otherwise, the motor will soon get
dirty and will be subject to wear. If the motor
filter gets dirty, the suction power will diminish.
Cleaning the exhaust air filter
Fig.
18
Possible causes
Interrupted power supply
• Filters are blocked with dirt
• Dust container full
• Suction hose/ telescopic tube
blocked with dirt
b) Re-assemble all of the components
that have previously been removed.
Assembly is carried out in reverse
order. When inserting the filter insert,
be aware that the arrow of the filter
points to the handle of the container.
Remove the motor filter and tap it
to remove the dust. Then re-insert it.
Reassemble all of the components
that have previously been removed.
Assembly is carried out in reverse order.
Warning!
Open the flap, take the filter out and
tap it to remove the dust. Assembly is
carried out in reverse order. Insert the
filter in the right direction so that the
correct side is facing the motor.
Solution
Check the power supply
• Clean and wash all filters
• Empty dust container
• Clean and wash the suction
hose/telescopic tube
8/6/18 9:46 am