LD Systems LAX20D Bedienungsanleitung Seite 9

1
LEFT(MONO)
RIGHT
19
TRACK IN/OUT
-TApE IN
Use the Tape input to connect a Tape Recorder or DAT. You can assign the signal coming from the Tape Recorder
either to CoNTRoL RooM/pHoNES output using the 2TK IN button on the front panel or to the MAIN MIX output
using the 2TK To MAIN MIX button.
- TApE oUT
These RCA sockets will route the main mix into a tape recorder.
- 2TK IN CoNTRoL
This control is used to adjust the level of 2TK IN signal, which can be varied from - ∞ to MAX.
20
STEREO AUX RETURNS
Each channel is equipped with the MUTE/ALT 3-4 switch. This switch is used to route the channel signal to ALT
3-4 output instead of the main mix.
21
AUX RETURN CONTROL
When pressing this button, the SoLo signal will replace other signals and reach to the CoNTRoL RooM/pHoNES.
Usually use the SoLo function to preview each channel signal before they are let into the mix.
It is useful to set an instrument's input level and EQ, and you can "solo" any channel that you want to. However,
the SoLo switch never affects any mix other than the pHoNES/CoNTRoL RooM mix.
22
EFX TO AUX 1
This switch will route the signal that is present at the AUX RETURN 2 jacks to AUX 1 output so that the effects
can be heard in the monitor mix.
23
AUX SENDS CONTROL
Both switches are used to determine the master AUX SENDS levels. The adjustable range is from – ∞ to + 15dB.
When the effect unit connected to mixer has no input gain control, you can get a further +15dB gain available
from these AUX SENDS outputs.
24
OUTPUT LEVEL LED DISPLAY
This stereo 12 segments LED meter will indicate the level of the overall output signal.
2
LEFT
RIGHT
STEREO AUX RETURNS
20
CONTROL eLeMentS:
2TK IN
L
R
TAPE IN TAPE OUT
2-TRACK IN/OUT
19
MAX
9