Rear Panel - LD Systems LAX20D Bedienungsanleitung

REAR PaneL:

44 42
PHANTOM
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
RIGHT
MAIN MIX OUTPUT(BAL/UNBAL)
ON OFF
AC INPUT
100-240V 50/60Hz Fuse:T1.6AL 250V
POWER CONSUMPTION: 40W
POWER
RIGHT LEFT
45
43 41
38
MONO CHANNEL INSERT
Insert sockets are provided for all mono MIC channels. It can allow you to patch external signal processing
devices into signal path via a TRS connector, the signal will be taken out after the input gain control (TRIM), and
sent to an external processor such as a compressor- limiter, then returned into the same channel immediately
before the EQ section.
Note: Usually, insert connections require a special stereo-splitting Y-cord to be connected, know as TRS connec-
tor (Tip Send/Ring return).
39
ALT OUTPUT
These 1/4'' sockets are unbalanced outputs. They are capable of delivering +22dBu. The signal level to the ALT
oUTpUT is adjusted by ALT 3-4 rotary on the front panel.
40
CTRL ROOM OUTPUT
These 1/4'' sockets are used to send the control room signal to the studio monitor speakers or a second
set of PA.
41
MAIN MIX OUTPUT
The stereo output is supplied both with XLR and 1/4'' TRS sockets, which are used to send the audio signal to an
amplifier. Through the main mix level control, you can adjust the output level from - ∞ to +10dB.
42
FOOT SW
This socket is used to connect external footswitch for a convenient operation, it will activate/deactivate the DSp
module in this unit and function same as DFX MUTE switch.
43
POWER ON/OFF SWITCH
This switch is used to turn the main power oN and oFF.
44
PHANTOM ON/OFF SWITCH
This switch will apply +48 Volt Phantom only to the 8 XLR microphone inputs. Never connect microphones when
the phantom power is already on.
45
AC INPUT
It is used to connect to main power.
LEFT
L
LEFT(3) 12 11 10
INSERT INSERT INSERT
R
OUTPUT RIGHT(4)
CTRL ROOM ALT OUTPUT
40 39
CAUTION CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
REPLACE WITH THE SAME TYPE FUSE AND RATING
WARNING: SHOCK HAZARD
- DO NOT OPEN DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
AVIS: RISQUE DE CHOC ELECTRIQUE
- NE PAS OUVRIR
8 7 6
9 5
INSERT INSERT INSERT INSERT INSERT
38
MODEL
SERIAL
4 3 2 1
INSERT INSERT INSERT INSERT