Attaching The Flushing Lines - Mettler Toledo InTrac 776-SL Betriebsanleitung

16
3. Check the vessel to ensure there are no obstacles in the ins-
4. Mount housing on the flange, align and tighten evenly cross-
Mounting with MNPT 1" external (male) thread
1. Wind Teflon
2. Screw the housing carefully into the counter-thread.
3. Check the installation for leaks.
4.2.2

Attaching the flushing lines

Important information
– When the electrode/sensor is withdrawn, small amounts of
– Use only corrosion-resistant and chemically resistant mate-
InTrac 777-SL-04-CH
52 400 841
ertion direction which would prevent motion of the immersi-
on tube.
wise with hex bolts and nuts.
® tape around the external (male) thread.
2
the process medium adhere to the electrode/sensor tip and
can enter the outflow line during the rinsing process. If the
process medium is an environmentally harmful substance
(toxic, corrosive, etc.), it is essential to comply with the local
regulations governing the installation of wastewater services.
rials for the rinsing water installation.
© 06/00 Mettler-Toledo GmbH, CH-8606 Greifensee
InTrac
1
® 777-SL / InTrac
Printed in Switzerland
® 776-SL