Operating Elements And Connections; Safety Notes - Monacor International JTS US-8001D/1 Bedienungsanleitung

All operating elements and connections can be
found on the fold-out page 3.

1 Operating Elements and Connections

1.1 Front panel
1 Receiving antennas
2 POWER switch
3 Power LED
4 Rotary switch* CH for adjusting the transmission
channel with the adjusting key supplied
5 Reception* LED RF;
lights up when a radio signal is received from the
transmitter
6 Audio signal LED* AF; lights to the rhythm of the
audio signal received
7 Volume control* VOL
*With model US-8002D/ 1, these operating elements are
available both for the receiving units CH 1 and CH 2.
1.2 Rear panel
8 Balanced XLR output for connection to the micro-
phone input, e. g. of a mixer or amplifier
Model US-8002D/ 1 has two outputs, one for the
output signal of the receiving unit CH 1 and one for
the output signal of the receiving unit CH 2.
9 Output (6.3 mm jack, unbal.) for connection to a
highly sensitive line input, e. g. of a mixer or ampli-
fier
With model US-8002D/ 1, the mixed signal from the
receiving units CH 1 and CH 2 is available here.
10 Strain relief for the connection cable of the power
supply unit:
Lead the cable around the hook to prevent acci-
dental disconnection of the plug from the jack (11).
11 Power supply jack for connecting the power supply
unit supplied

2 Safety Notes

The units (receiver and power supply unit) correspond
to all required directives of the EU and are therefore
marked with .
WARNING The power supply unit is supplied with
hazardous mains voltage (230 V~).
Leave servicing to skilled personnel
only. Inexpert handling may cause an
electric shock hazard.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not operate the receiver and immediately discon-
nect the power supply unit from the mains
1. in case of visible damage to the units or to the
mains cable,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled per-
sonnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not cor-
rectly connected, operated, or not repaired in an
expert way.
If the units are to be put out of operation de -
finitively, take them to a local recycling plant
for a disposal which is not harmful to the envi-
ronment.
®
7