Changing The Battery - HomeMatic HmIP-FCI1 Bedienungsanleitung

Changing the battery

• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. The device number can be found on
the sticker supplied or attached to the device.
• Please wait until teach-in is completed.
If teaching-in was successful, the LED (A) lights
•
up green. The device is now ready for use.
• If the LED lights up red, please try again.
• Please select the application (for example, light
and/or security) in which the device will be used.
• In the app, give the device a name and allocate
it to a room.
6 Changing the battery
Only slide the battery holder into the device if it
contains a battery, otherwise it can no longer be
removed.
If the app or device displays an empty battery (see Section
„7.4 Error codes and flashing sequences" on page 32),
or if there is no response from the device in question after
pressing the pushbutton, replace the old battery with a
new CR2032 one.
Open the battery compartment (B) by pulling out
•
the battery holder (C) (see Figure 3).
28