Maintenance; Information About Demolition; Environmental Information - Corghi ProLine 640 Betriebsanleitung

assistance service with precise information
in order to minimise dela�s.

maInTEnanCE

WARNING
The compan� is not to be held responsible
for an� claims deriving from the use of
non�original spare parts or accessories.
WARNING
Unplug the machine from the socket and
make sure that all moving parts have been
locked before making an� adjustments or
maintenance work.
�o not remove or modif� an� part of the
machine (e�cept for service interven�
tions).
WARNING
Keep the working area clean.
Never use compressed air and/or jets of
water to remove dirt or residues from
the machine.
Take all possible measures to prevent
dust from building up or raising during
cleaning operations.
Keep the wheel balancer shaft, the secur-
ing ring nut, the centring cones and flange
clean. These components can be cleaned
using a brush previously dripped in envi-
ronmentally friendly solvents.
Handle cones and flanges carefully so as
to avoid accidental dropping and subse-
quent damage that would affect centring
accuracy.
After use, store cones and flanges in a
place where they are suitably protected
from dust and dirt.
If necessary, use ethyl alcohol to clean the
display panel.
Perform the calibration procedure at least
once every six months.
User manual ProLine 640
InFormaTIon
aBoUT
DEmoLITIon
If the machine is to be scrapped, remove
all electrical, electronic, plastic and metal
parts
and dispose of them separately in accord-
ance with current provisions as prescribed
by law.
EnVIronmEnTaL
InFormaTIon
The disposal procedure described below
only applies to machines with the symbol
of the waste bin with a bar across it
on their data plates.
This product may contain substances that
can be hazardous to the environment and
to human health if it is not disposed of
properly.
We are therefore providing you with the
information below in order to prevent these
substances from being released into the
environment, and to improve the use of
natural resources.
Electrical and electronic equipment must
never be disposed of in the usual municipal
waste but must be separately collected for
their proper treatment.
The crossed-out bin symbol, placed on
the product and on this page, reminds the
user that the product must be disposed of
properly at the end of its life.
Thus, the hazardous consequences that
non-specific treatments of the substances
contained in these products, or improper
use of parts of them, may have on the
environment or on human health are pre-
vented. Furthermore, this helps to recover,
UK
65