Maintenance Plan; Troubleshooting; Safety; Service Address - AL-KO SOLO FC 13-90.5 HD 2WD Bedienungsanleitung

6.3

Maintenance plan

Maintenance
Cleaning
Check safety precautions
Check all screws for tight seat
Check motor oil level
Check air filter
Clean or replace air filter (normal use)
Clean or replace air filter (dusty conditions)
Adjust tire pressure
Check machine for damage or corrosion on paint
coating and remedy as appropriate
Grease rotating points and joints
Check machine for fuel or oil leaks
Replace fuel filter
Replace spark plugs
X = Described in this Operation Manual in the indicated section.
O = Not described in the present Operation Manual
B = Description is enclosed in attached motor operation instructions.
7

Troubleshooting

7.1

Safety

Procedure for failures and accidents
1. Initiate emergency stop (leave working position).
2. Stop the machine.
3. Determine the failure cause.
4. Remedy failure or contact specialist dealer.
7.3

First action for troubleshooting

Failure Cause / Remedy
Check tank filling level and refill as appropriate
Check and adjust choke setting
Motor will not start
Ignition plug failure
Fuel pump clogged
Check battery and load or refill as appropriate
Starter does not
move
Contact to battery poles insufficient
Ignition plug failure
Motor is running
Clean air filter - See Maintenance
rough
Clean fuel filter - See Maintenance
Battery cells are damaged
Battery cannot be
Battery acid level too low
loaded sufficiently
Contact problems, clean and grease poles
Air in gear unit
Drive performance
accelerator pedal several times, both forward and backward (bleeding). In case of
null or weak
insufficient remedy, please contact your authorized dealer.
Translation of the original operating instructions
Prior to each use
X (Item 6.2.1)
X (Item 6.2.2)
O
B
B
O
O
O
7.2
Please contact your sales consultant in case of failures,
problems or otherwise. Please always indicate the machine
serial no. in inquiries. (Please refer to nameplate on the
machine or on the Operation Manual cover).
.
Clean ignition plug contacts or replace ignition plug
Check pump and clean fuel filter
clean and grease poles
Clean ignition plug contacts or replace ignition plug
Replace battery
Refill distilled water
Set both gear units to manual operation, start motor and push
Annually Intervals in hours
25 50
B
O

Service address

100 200
B
B
B
Notes
- 12 -