ELNA eXpressive 820 Gebrauchsanleitung Seite 34

q
w
Using both hand, pull thread towards left and
insert thread into slit.
q
Pull the thread (dotted line in illustration) around
the thread guides following the broken lines
q
indicated on the machine .
3 2 1
Pass the thread through the hole in the bobbin
from inside to the outside. Place the bobbin on the
w w
bobbin winder spindle .
Push bobbin winder spindle to the right. (The LCD
touch screen will show a bobbin winding
message.) Holding the free end of the thread,
press the Start/Stop key. Stop machine after the
bobbin has made a few turns. Cut the thread tail
close to the hole in the bobbin. Start machine
again to continue winding bobbin. When the
bobbin is fully wound, stop the machine.
e
Move the spindle to the left to return the bobbin
winder to its original position. Remove the bobbin
and cut the thread with the bobbin winder cutter
e
.
NOTE: Do not move the bobbin winder spindle
while the machine is running.
If the machine is running for more than two
minutes during bobbin winding, it will automatically
stop for safety purposes.
32