Setting And Starting Aprogramme; Setting Mode - AEG GS45BV221 Benutzerinformation

SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on.
If the control panel shows other condi-
tions, press and hold function buttons (B)
and (C) at the same time until the appli-
ance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
3. Make sure that the appliance is in set-
ting mode.
4. Set the programme.
• The related programme indicator
comes on.
• The programme duration flashes in
the display.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration that
decreases with steps of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the display shows the delay
time you want to set (from 1 to 24
hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Close the appliance door. The count-
down starts.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hours.
• When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
1. Open the appliance door.
2. Press the delay button again and
again until the display shows the pro-
gramme duration.
3. Close the appliance door. The pro-
gramme starts.
Cancelling the programme
Press and hold function buttons (B) and
(C) at the same time until:
• All the programme indicators come on.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates and
the display shows 0.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off but-
ton, the AUTO OFF device auto-
matically deactivates the appli-
ance after some minutes. This
helps to decrease the energy con-
sumption.
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
There can be water on the sides
and on the door of the appliance.
Stainless steel becomes cool
more quickly than the dishes.
ENGLISH
73