SOMFY S&SO-RS100 io HYBRID Anleitung Seite 58

EN
Operate the roller shutter and allow it to stop
3)
automatically at the upper end limit (if stops) or
lower end limit (if rigid links).
Press once on
4)
back and forth movement by the roller shutter:
7KH VHWWLQJ IRU WKH ¿UVW HQG OLPLW LV FRQ¿UPHG
Move the roller shutter to the desired lower end
5)
limit (no rigid links) or upper limit (no stops).
Press once on
6)
are two back and forth movements by the
roller shutter:
7KH VHWWLQJ IRU WKH HQG OLPLWV LV FRQ¿UPHG DQG WKH GULYH H[its set mode.
The procedure for modifying the end limit settings is identical to the initial setting
procedure. To modify the settings at a later time, repeat step A1
Step A2 (optional): Programming a io-homecontrol
This guide describes the programming of a Somfy Smoove io type io-homecontrol
point.
Position the roller shutter at its half-way position.
1)
On the wired control point, press three times
2)
on and press once on
and forth movement by the roller shutter:
The radio is activated and the drive is in
programming mode.
7KH GULYH LV LQ SURJUDPPLQJ PRGH IRU §  PLQ
%ULHÀ\ press the PROG button on the Somfy
3)
®
io-homecontrol
programme:
The roller shutter moves back and forth: the
control point has been programmed in the
drive.
Certain control points are equipped with an ON/OFF button. To activate them, press
the ON/OFF button at the rear of the control point.
1
7KH URWDWLRQ GLUHFWLRQ RI WKH GULYH VHOIDGMXVWV DXWRPDWLFDOO\ GXULQJ WKH ¿UVW IHZ
cycles. 'XULQJ WKH ¿UVW IHZ PRYHPHQWV RI WKH UROOHU VKXWWHU WKH RUGHUV 9 may be
inverted (they adjust automatically without the need for any settings, after a maximum
of 2 complete cycles, from one end limit to the other). For a roller shutter below 0.5 m²
(0.6 mx 0.7 m), see Questions on the S&SO-RS100 io HYBRID? section.
8
Copyright © 2014 - 2015 Somfy SAS. All rights reserved.
and press until there is
and press
until there is back
local control point you want to
3)
5)
until there
®
control point
1)
3)
4)
x 1
2.5
S
6)
x 1
2.5
S
b
.
2)
x 3
2.5
S
PROG. 0.5
S
Non contractual images.
2
X
® control