Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
Fig. 32
4
82
man_P(H)5xx('17).indd 82
• Never wash the appliance with water. It could be dangerous.
• Never use petrol, alcohol or solvents to clean the appliance.
• Never spray insecticide liquids or similar.
J
START-END OF SEASON OPERATIONS
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and the earth system is
efficient. Follow the installation instructions precisely.
END OF SEASON OPERATIONS
To empty the internal circuit completely of water, remove the cap(fig. 32).
Run off all water left into a basin. When all the water has been drained, put the
cap back in place. Clean the filter and dry thoroughly before putting back.
L
TROUBLE SHOOTING
Phenomenon
Troubleshooting
The appliance does
• There is no current
not come on
• It is not plugged into the
mains
• The internal safety device has
tripped
The appliance works
• Here are bends in the air
for a short time only
exhaust hose
• Something is preventing the
air from being dis charged
• Windows, doors and/or
curtains open
• There are heat sources in the
room (oven, hairdryer, ate)
The appliance works,
but does not cool the
• The air exhaust hose is
room
detached from the appliance
• The technical specification of
the appliance is not adequate
for the room in which it is
located
During operation,
• Air filter clogged
there is an unpleasant
smell in the room
The appliance does
• The internal compressor safety
not operate for about
device prevents the appliance
three minutes after
from being restarted until
restarting it
three minutes
The following
• The appliance has a self
message appears on
diagnosis system to identify a
the display:
number of malfunctions
Never attempt to disassemble or repair the device. Inexpert repairs invalidate the
guarantee and can endanger the users of the device.
Solution
•Wait
• Plug into the mains
• Wait 30 minutes, if the problem
persists, contact your service center
• Position the air exhaust hose
correctly, keeping it as short and
free of curves as possible to avoid
bottlenecks
• Check and remove any obsta-cles
obstructing air discharge
• Close doors, windows and curtains,
bearing in mind the "tips for
correct use" given above
• Eliminate the heat sources
• Fit the air exhaust hose in the
housing at the back of the
appliance
• Clean the filter as described there is
an above
• Wait. This delay is part of normal
operation
• See the SELF-DIAGNOSIS Chapter
27-12-17 12:31

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

P534P528Ph534

Inhaltsverzeichnis