Install The Hardware; Wall Mount - Axis V5915 Installationshandbuch

Install the Hardware

There are three ways to install the camera:
NO TICE TICE
NO NO TICE
The camera shall be installed upright or upside down, never sideways or at an angle.
• Standing on a table top.
• Hanging on a wall, see Wall Mount on page 15
• Hanging from a drop ceiling, see Drop Ceiling Mount on page 16
To install the camera on a table top:
1. Place the camera on a table top or other horizontal surface. Make sure that the surface
is stable.
2. Insert the SD memory card (optional).
3. Connect the required cables to the camera.
NO TICE TICE
NO NO TICE
Be careful not to stretch or bend the cables too much. This could cause damage to the
cables.
4. Connect the power supply to a mains power outlet (100–240 VAC).

Wall Mount

WARNING
The combined weight of the camera and mounting bracket is approximately 1.7 kg (3.7 lb.).
Make sure that the wall material is strong enough to support this weight.
1. If required, route the cabels through the wall.
2. Install the mounting bracket on a wall and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
3. Insert the SD memory card (optional).
4. Mount the camera on the mounting bracket and tighten the tripod screw.
AXIS V59 Series
15