Care And Maintenance; Firmware Updates; Flash Capacitor Forming - Metz mecablitz 44AF-2 digital Bedienungsanleitung

13 Care and maintenance

Remove dust and grime with a soft dry
cloth or silicon-treated cloth. Do not
use cleaning agents as these may
damage the plastic parts.

13.1 Firmware updates

Flash unit firmware can be updated via
the USB port and, within the techni-
cal framework, adapted to the functio-
nality of future cameras.
Checking the firmware version
• Switch off the flash unit by pressing
the button until all LED dis-
plays are off.
• Hold down the TTL button
flash unit whilst pressing the
button.
On the flash unit, the M button
the LED for partial light output
and 1/32 will flash.
The number of flashes shows the firm-
ware version e.g. 1/1 LED flashes once
and the 1/64 LED 3 times to install
firmware version 1.3.
SL
M
on the
TTL LED
and
1/1 1/2 1/8 1/32
1/1
SL
M
TTL LED
Further information can be found on
the Metz website:
www.metz-mecatech.de

13.2 Flash capacitor forming

The flash capacitor built into the flash
unit undergoes physical change if the
unit is not switched on for a prolonged
period. For this reason it is necessary
to switch the unit on for approximately
10 minutes at least once every three
months. The power supplied by the
power source must be sufficient to cau-
se the flash readiness indicator to light
up no more than one minute after the
flash unit is switched on.
+
k
123