Mounting The Flash Unit; Switching The Flash Unit On And Off - Metz mecablitz 44AF-2 digital Bedienungsanleitung

disposed of with domestic waste. Do
your bit for the environment and dispo-
se of used batteries/rechargeable bat-
teries at designated collections points.

3.2 Mounting the flash unit

Mounting the flash unit on the camera
Turn off the camera and flash before
mounting or removing.
• Turn the knurled nut
flash unit housing as far as it will go.
The locking pin in the adapter shoe is
now fully retracted into the case.
• Slide the flash unit foot completely
into the camera accessory shoe.
• Turn the knurled nut
camera housing as far as it will go,
clamping the flash unit in place. If the
camera does not have a locking hole,
the spring-loaded locking pin retracts
into the adapter case so as not to
damage the surface.
towards the
towards the
Removing the flash unit from the
camera
Turn off the camera and flash before
mounting or dismounting.
• Turn the knurled nut
flash unit housing as far as it will go.
• Remove the flash unit from the came-
ra's accessory shoe.
3.3 Switching the flash unit
on and off
• Switch on the flash unit by pressing
the button The unit will revert
to the last operating mode and the
LED display will light up accordingly.
The button �flashes red in standby
mode. Switch off the flash unit by pres-
sing the button a �until all LED dis-
plays are off.
In the event that the flash unit will not
be required for a longer period of time,
we recommend switching the unit off
by pressing the a button and remo-
ving the power supply (batteries,
rechargeable batteries).
towards the
k
107