Cutting Variants - Storch ProCut multi Bedienungsanleitung

Cutting variants

Straight cut (longitudinal and lateral cut):
Mitre cut:
Transfer the slope to the foam board using a sliding bevel (art. no. 36 82 00 - not supplied) and position
the board on the bearing rail (no. 8). Extract the cutting bow, loosen the set screw (no. 7) for the bearing
Position the foam board on the bearing rail (no. 8), then extract the cutting bow
(no. 1), slide the foam board to the left up to the cutting dimension (required board
width - can be read on the measuring scale of the bearing rail (no. 8)) and then
guide the cutting bow gently through the foam board. The board can be positioned
vertically or horizontally on the bearing rail (no. 8) to enable longitudinal or lateral
cuts. To make repeated cuts of the same length, raise the slider for repeat cuts
(no. 12) and secure it in place at the required measurement. If you wish to make
longer cuts the slider can be lowered and maintained at the previously set mea-
surement.
Transfer the mitre angle from the object to the horizontal foam board using a sli-
ding bevel (art. no. 36 82 00 - not supplied); then unfold the mitre aid (no. 16),
position the board on the bearing rail (no. 8), loosen the set screws (no. 5 and no.
6), then pivot the cutting bow (no. 1, fig. 1) to the right until the mitre aid (no. 16)
of the cutting bow (no. 1) corresponds with the marking on the foam board. Retigh-
ten the upper and lower set screws (no. 5 and no. 6). Now set the board to be cut
vertically on the bearing rail (no. 1) and guide the wire through the board.
Diagonal cut:
rail and raise the support (no. 8) with the foam board until the wire of the cut-
ting bow (no. 1) corresponds with the marking on the foam board. Retighten the
set screw (no. 7) and guide the cutting wire through the board. If another cutting
method is going to be used after making this cut, make a note of the angle (which
can be read below on the base plate). Doing this will enable you to quickly repro-
duce the angle.
49