Cutting Difficult Or Abrasive Materials - Westfalia 56 73 39 Bedienungsanleitung

firmly. Then push the tool forwards along the line to be cut. Never draw the
tool backwards.
3. Once the finish line has been reached, lift the tool from the work surface
before switching off. If a lot of dust has been created, keep switched on for
a few seconds extra to allow the dust to clear from within the tool.

Cutting Difficult or Abrasive Materials

Practice using the tool by cutting wood before attempting to cut anything
tougher. When cutting tougher material, such as metals and some plastics,
more force is required to hold the work piece and clamping may be required.
Do not cut materials that produce toxic dust or fumes such as PTFE or
asbestos.
Sheet metal:
Always set the depth adjustment to at least 1 mm greater than the material
thickness to avoid the blade riding up over the surface. Scrap material is
required underneath the work surface.
Remove burrs and rust as these impede the feed across the material.
Do not cut steel or galvanised steel.
Every 2 minutes of metal cutting should be followed by a rest of at least 3
minutes.
Ceramic Tiles, Slates etc:
Only use a blade specifically designed for the purpose.
Always use with a suitable vacuum cleaner or dust extractor connected as
the dust can be hazardous to the operator and prevent the guard from
operating correctly.
Applying masking or PVC tape to the base plate of the tool, or alternatively
to the work piece can make cutting easier and avoid scratching the tile.
Plasterboard:
This saw is only recommended for making occasional cut outs in
plasterboard, and should only be used with a suitable vacuum cleaner or
dust extractor connected. The dust can prevent the guard operating
correctly.
Although conventional tools such as keyhole saws or knives generally give
excellent results, the Precision Saw is ideal if a particularly neat, dust free
cut is required or if there is a danger of cutting pipes or cables.
Operation
14