STEINEL IR Quattro HD KNX Bedienungsanleitung Seite 9

Detection Zone
IR Quattro KNX / IR Quattro HD KNX
presence
radially
tangentially
Reliable presence detection largely depends on
the number, condition and arrangement of the
lens segments. The IR Quattro KNX with its
square detection zone of 16 m 2 divided up into
13 levels and 1760 switching zones senses the
smallest of movements. With a square detec-
tion zone covering an area of 64 m , the IR
2
Quattro HD KNX has 4800 switching zones that
Reach Setting
(PC IR Quattro / IR Quattro HD KNX)
Potentiometer g
Adjusts reach to specific specifications for selecting
requirements. See table on settings to suit specific require-
pages 4/5 showing technical ments.
tangentially
radially
presence
provide even greater precision. These reaches
can be adjusted to suit specific requirements at
the setting potentiometer. The square detection
zone and the capability of interconnecting mas-
ter/slave versions provide the basis for creating
optimum configurations quickly and easily.
- 16 -
Reach Setting
(HF 360 KNX / DUAL HF KNX)
HF 360 KNX-mounting height 2.8 m
HF 360 KNX reach can be selected using the
remote control RC 6 (see Accessories) as well
as ETS Software/KNX BUS (refer to calibration
description, www.knx.steinel.de). 1 or 2 detec-
tion directions can be masked out for adjustment
to the room situation. An angle of coverage of
Electrical Installation / Automatic Mode
In selecting the wiring leads, it
is important to meet the wiring
regulations laid down in
VDE 08 29 (DIN EN 5000 90) -
(see Safety warnings on page 14).
DUAL HF KNX-mounting height 2.8 m
360° provides a max. reach of 8 m. The DUAL
HF KNX sensor has 2 special HF sensors that
detect movement from the ceiling in both direc-
tions. Reach is electronically selectable in ei-
ther direction.
- 17 -