Contents of the product
- 1 bark limiter collar fitted with short contact
points and a rechargeable battery
- 1 nylon strap
- 1 charging station
Description of the product
Indicator light:
On/Off indicator
+
battery level indicator
Charge of the battery
WARNING: it is necessary to fully charge the battery of your bark limiter collar before the
first use.
To charge the battery of your collar, it must be turned off.
To charge your product, proceed in the following way:
- Connect the charger to the charging station.
- Connect the charger to a wall outlet.
- Put the collar on the charging station (make sure to respect the orientation of the collar on
the charging station – see Diagram 2). After a few seconds, the indicator light on the collar
starts blinking in green.
- When the battery is fully charged, the green indicator light switches off.
- Remove the collar from the charging station.
- Disconnect the charger from the wall outlet.
A full charge takes approximately 5 hours.
Diagram 1
- 1 charger
- 1 magnetic key (magnet)
- 1 pair of long contact points
- 1 neon test lamp
- This user's guide
2 contact points
(short or long)
Gb - 15
Bark detection
contact point
Nylon strap
symbol:
area where the magnet is located
to switch On/Off the collar
or change operating mode