Air Supply; Supply Of Chemical Products; Hose Connection; Operation Procedures - ECOLAB Griff Gebrauchsanweisung

6.8. Air Supply

The unit have an internal air supply via a
compressor.
No special actions are necessary before
use.
6.8.1.

Supply of chemical products

Satellite without User Pack System.
• Place the cans with chemical products in the can
holder
• Check the suction filters for impurities.
• Put the suction hoses into the cans below product
level and avoid suction of air.
• After pre-rinsing, check again that the hoses is
sufficiently below product level and avoid suction
of air during foam or spray operation.
• After use of and when changing product as well
as after use of the unit, remove the hoses from the
cans and rinse the product inlet lines and injectors
with clean water.
Unit with User Pack System
See drawing no 110003485.
• Place the specially designed User Pack in the
automatic holder.
• If changing to a different product when ending the
cleaning process, rinse the product inlet line with
clean water as follows:
Replace the User Pack containing product by one
with clean water; place the foam nozzle and open the
spray gun/outlet valve. The product inlet line is now
rinsed with clean water before use of another product
.

6.9. Hose Connection

• The special hose fitted with spray gun/outlet valve
is connected to the outlet quick coupling of the unit
(layout drawing).
• Maximum hose length: 25 m/ 82 ft.
• It is recommended only to use Nilfisk FOOD
hoses, which have been tested for chemical resist-
ance and general wear and tear.

7. Operation procedures

7.1. Start up

7.1.1.

Start

1. Make sure that the power supply is connected
and the water air supply to the unit is open.
2. Select requested function. Use the unit according
to the "User Guide".
7.1.2.

Stop

1. Close the water supply.
2. Connect the power supply.
3. Deactivate chemical supply by pulling up the suc-
tion hose or removing the userpack.
>20 sec.
XP Foame
Installatio
guid
110003704
110003703
H20
H20
110003485
17
XP
In