Zanussi ZWHB 7146 AP Benutzerinformation Seite 29

Malfunction
Spinning starts late or
the appliance does not
spin:
No water is visible in
the drum:
Unsatisfactory washing
results
The appliance makes an
unusual noise
After completing these checks, switch on the
appliance and press the button 9 to restart the
programme.
If the malfunction shows again, contact your
Service Centre. The necessary data for the
Mod. ... ... ...
Prod. No. ... ... ...
www.zanussi.com
The electronic unbalance detection device has cut in because the laundry is not
evenly distributed in the drum. The laundry is redistributed by reverse rotation of
the drum. This may happen several times before the unbalance disappears and
normal spinning can resume. If, after 10 minutes, the laundry is still not evenly
distributed in the drum, the appliance will not spin. In this case, redistribute the
load manually and select the spin programme.
• Load more laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the spinning
programme.
Appliances based on modern technology operate very economically using very
little water without affecting performance.
Too little detergent or unsuitable detergent has been used.
• Increase the detergent quantity or use another one.
Stubborn stains have not been treated prior to washing.
• Use commercial products to treat the stubborn stains.
The correct temperature was not selected.
• Check if you have selected the correct temperature.
Excessive laundry load.
• Reduce the laundry load.
The appliance is fitted with a type of motor which makes an unusual noise com-
pared with other traditional motors. This new motor ensures a softer start and
more even distribution of the laundry in the drum when spinning, as well as in-
creased stability of the appliance.
Ser. No. ... ... ...
Possible cause / Solution
service centre is on the rating plate. We recom-
mend that you write the data here:
Model description (MOD.) ...............................
Product number (PNC) ...................................
Serial number (S.N.) .......................................
29