Herunterladen Diese Seite drucken

Num'axes EYENIMAL Small Bark Control Gebrauchsanleitung Seite 8

Vorschau ausblenden Andere Handbücher für EYENIMAL Small Bark Control:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15
A full charge takes approximately 5 hours.
Activate/Deactivate the collar
Activate: move the magnetic key towards the collar so that it comes into contact with the
Diagram 3). A Beep sound will be emitted and the indicator light will flash in green (1 flash every 5 seconds) indicating that the
collar has been switched on.
Deactivate: move the magnetic key towards the collar so that it comes into contact with the
Diagram 3). Two beep sounds will be emitted and the indicator light will flash in red ndicating the collar has been switched off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
Operation
At the first bark, a beep sound is emitted. If another bark is detected within 30 seconds, another beep sound is emitted together
with a static timulation (progressive stimulation for sensitive dog or difficult dog according to the selected operating mode).
Inhibition of any further stimulation is dependant on the absence of any barking within the next 30 seconds.
The stimulation function can be inhibited selecting operating mode Nr 1. In this case, only beep sounds will be emitted.
After being activated 9 times in quick succession, the collar will automatically go into safety mode for 2 minutes
before restarting itself normally.
Changing operating modes
In the factory, the collar is set to mode Nr 2 (beep sound + progressive stimulation for sensitive dog).
To change the collar's mode, proceed in the following way:
When switching on the collar, keep the magnetic key in contact with the
After the beep sound indicating that the collar is on, a series of beep sounds together with indicator light flashes is emitted (from 1
to 3) indicating the selected mode.
Keep the magnetic key in contact with the
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously selected.
The chart below indicates how your collar operates according to the mode you have selected:
Number of beep sounds together
with indicator light flashes
emitted when switching mode
1
2
3
Checking/reloading collar battery
5 beep sounds + indicator light flashes in red 5 times when turning on/off the collar = the battery is too low.
When the battery is too weak, the product switches to safety mode and the system locks up.
You must charge the battery (full charge takes approximately five hours - see § Charge of the battery).
Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact with
the dog's skin, enabling the device to operate correctly (proper barking detection and correct transmission of the stimulations).
Diagram 2
Diagram 3
symbol to run through modes.
Mode
Nr 1
Beep sounds only
Nr 2
Beep sound + progressive stimulation for sensitive dog
Nr 3
Beep sound + progressive stimulation for difficult dog
symbol, hold for 1 second (See
symbol, hold for 1 second (See
symbol on the front of the collar (See Diagram 3).
Operation
8/28

Werbung

loading