12 www.electrolux.com
2. Open the window sash and place the
window slider kit on the window stool
(Fig�9)� Attach the window slider kit to
the window stool� Adjust the length of
the window slider kit according to the
width of window� Screw down the two
screws on the window slider kit� See
Fig�9�
67.5cm~123cm
Cut the adjustable window slider kit
if the width of window is less than
67�5 cm (Fig�10)�
Cut this to fit your window
3. Close the window sash securely against
the window slider kit�(Fig�11)
4. Drive two 12�7mm screws to secure the
window slider kit to the window sash�
(Fig�11)
5. Secure the window slider kit to the
window stool(Fig�11):
A: For wooden window: Use 19mm
screws for securing�
B: For Vinyl-Clad windows: Use 12�7 hex
head cap screws for securing�
Foam seal A
(adhesive type)
screws
Window slider kit
Window stool
Fig.10
12.7mm crews
Fig.8
19mm screws or 12.7mm
hex head cap screws
6. To secure lower sash in place, attach
right angle sash lock with 12�7mm
screw as shown(Fig�12)�
It is difficult to lock the windows
with the safety lock for Vinyl-Clad
windows, so you can use lock by
window itself�
Fig.9
7. Cut the foam seal B to an appropriate
length and seal the open gap between
the top window sash and outer window
sash, as shown in Fig�13�
5.2 Installation in a sliding sash
window
1. Cut the foam seals A(adhesive type) to
the proper lengths and attach them to
the window frame� See Fig�14�
Foam seal A
(adhesive type)
s
Window slider kit
Window stool
Foam seal B
Fig.11
Fig.12
Fig.13
Fig.14